Skip to main content

How to edit properties in Factory Map

Anita Vithayathil
  • Updated

 

đź“ŤImportant: How Property Inheritance Works in Factory Map

Properties set at higher levels Site → Area → Line → Machine are automatically passed down to all levels beneath them unless you explicitly override them.

  • If you set a property at the Site level, every Area, Line, and Machine under that Site will inherit the same value.
  • You can override a property at any lower level, and that override applies only to that specific level and anything below it.

Example

If the Site has a property FPY_Target = 95%, then all Areas, Lines, and Machines will show FPY_Target = 95%.
However if you go to a specific Machine and set FPY_Target = 99%, then that machine will use 99% instead of the inherited 95%.

 

 

Step-By-Step Guide

  1. Navigate to Factory Map

  1. Click "Machine" to edit Machine properties.

  1. Click 'Select Columns' to see a full list of available properties. Those properties appear as columns to the right of the table view.

  1. In this example, I am selecting "Sn (Machine)" and "Year (Machine)" field.

  1. Click "Apply"

  1. Now click on 'Edit Mode' to bulk edit the properties.

  1. Make changes as desired.

  1. Click "Review Changes"

  1. You may choose to discard any changes here. Once ready, click Confirm.

  1. Click "Exit" to exit 'Bulk Edit' mode.

  1. Notice that the SN and Year property have been updated.

 

Related articles

Comments

0 comments

Please sign in to leave a comment.